- January 19, 2020 at 6:39 pm #12131Jeffrey JoyceParticipant
I am trying to put attic vents in a wall above garage doors (see PDF)January 19, 2020 at 6:42 pm #12132Jeffrey JoyceParticipant
The wall will not auto extend to the roof, So I created two sloped walls. Due to it being two walls I cannot located the Louvered vent (round window) centered in the wall. Does anyone have any ideas on how to resolve this issue?January 21, 2020 at 5:28 pm #12138FynrDzynrParticipant
Walls won’t auto-extend to a roof on a different location.
If this is the case, why not create a new wall on the roof location, make sure it’s base is at the top of the garage wall (top level of course) and insert attic vents there?January 22, 2020 at 12:00 pm #12140SDSParticipant
Another approach is to set your “display gable” to Wall and select an appropriate wall type in the drop-down that becomes available below it. You can insert windows etc into gables using this method.
The issue with this method is that “display gable” walls are inserted “on center” so you have to adjust your roof insertion line to the mid-point of the wall below, instead of exterior edge in order for the gable wall to align vertically with the wall below, otherwise it will hang over. Also, add that half-wall thickness to your gable’s overhang to set it in the correct position.
I probably use the method FynrDzynr suggested more often though, depends on the situation.
- You must be logged in to reply to this topic.